common problems for laser cutting engraving system
2016-07-26 10:05:31 From:www.firmcnc.com Views:
common problems for laser cutting engraving system
---If the Boot but laser cutitng machine is not start
1.Check whether the machine electricity is ok
2.check the main parameters is correct
Method:
1.check the electrical wires again
2.set up the parameters refer by software instructions
---If Working without laser
1.Check wether the optical path is skewing
2.Line problem
Method :
1.Adjust the light path
2.Judgment with plug the rays into the power of the signal terminal
---The laser on and off at work
1.Check whether the water cycle is ok
2.whether the supply voltage is stabilize
Method :
1.Clean the water tank and water pump,clear the pipe
2.Add voltage stabilize to power supply
---The online data can’t be disposed
1.whether the communication cable is connected
2.whether the software USB is installed
Method :
1.Shutdown and reconnect the cable
2.Reinstall the software and USB drive
---Processing size does not consistent with software set
1.Install the software
2.Adjust action
Method:
1.install the original software torecover original parameters
2.sized the working area and trim size .calculate refer to software
---The control panel no light
1.Line is loose
Check whether the connecting line is loose from main board to panel
---If Boot reset is limited
There is problem of limit switch and signal
Check parameter of software and limit switch setting
---If Carving dislocation
1Electrostatic interference
2Drive parts is loose
Method:
1.Reconnect ground wire two meters below ground
2.Check if the gear top silk and strap is loose